Lab Grown Diamonds

Lab Grown Diamonds: Stone Choice: Moissanite, Lab Grown Diamond and Zircon in Wholesale - HOLYCOME

Lab Grown Diamonds: Stone Choice: Moissanite, Lab Grown Diamond and Zircon in Wholesale - HOLYCOME

The stone on lab grown diamonds decides three things at once: the retail price, the disclosure you must make, and the returns rate. Choosing it by sparkle alone is how buyers end up with a listing that cannot be defended.

Moissanite: the value stone

Moissanite is silicon carbide, hardness 9.25, with more fire than diamond. On lab grown diamonds, it delivers a diamond-like look at a fraction of the cost, and it is the stone most US buyers can sell at USD 80 to 200 retail.

The variables are cut quality and colour grade. A well cut near-colourless stone looks clean; a poorly cut one shows a bow-tie under office light.

Ask for the mill certificate and the stone invoice. Two documents turn a material claim into something an auditor can check.

Lab grown diamond: the bridal stone

Lab grown diamond is chemically diamond, hardness 10, and needs the same disclosure as natural. It carries a certificate cost that moissanite does not, which matters at wholesale volume.

Use lab grown on lab grown diamonds when the retail price supports a certificate and the buyer can answer the disclosure question.

StoneHardnessSparkleCertificateRetail band
Moissanite9.25High fireOptionalEntry to mid
Lab grown diamond10DiamondRequired at gradeMid to high
Natural diamond10DiamondRequired at gradeHigh
CZ8.5Bright, flatNoneEntry

Read the table as a checklist rather than a recommendation. The right row depends on the price band, the wear pattern and the channel you sell into.

Write the remedy matrix before the first defect: remake, credit, allowance or rework, each tied to a defect class.

Zircon and cubic zirconia: the entry tier

CZ is hard enough for fashion and cheap enough for test orders, but it clouds over time and it cannot carry a diamond claim. Zircon is a natural stone with lower hardness and a different care story.

Keep these clearly labelled in the listing. A mislabelled stone is a compliance problem, not a margin decision.

Specifying the stone so the lot matches the sample

Write five fields: stone type, size in millimetres, colour grade, cut and setting type. Add the tolerance: plus or minus 0.2 mm on the seat, and a colour match within one grade.

Photograph the approved stone next to a ruler. That photo is the reference for every later lot.

A supplier who will name the mill, the stone source and the plating shop is a supplier you can audit. A supplier who will not is a price with no chain behind it.

What to check before the order

Run the five checks below in order. The first two protect the money, the last three protect the launch date.

  • Write stone type, size, colour and cut into the PO.
  • Photograph the approved stone next to a ruler.
  • State the disclosure wording on the listing.
  • Check the seat tolerance, not just the stone size.
  • Never let a CZ be sold as a diamond.

If a supplier cannot answer three of the five, treat the quote as a starting point rather than a plan. Ask again in writing and keep the answer with the PO.

Frequently Asked Questions

Is moissanite a good stone for lab grown diamonds?

Yes for value-driven lines. It is hard, bright and inexpensive, provided the cut is good and the listing says moissanite.

Do lab grown diamonds need a certificate?

At most US retail price points, yes, and the listing must state lab grown. Certificate cost is part of the landed price.

Can I mix stone types in one design family?

Yes, but keep the SKUs separate and label each clearly. Mixed labelling is where compliance problems start.

How do I check the stone size in a lot?

Measure ten stones per size with a caliper and compare to the approved reference photo.

What is the most common stone complaint?

A colour mismatch against the sample, usually because the factory switched rough without telling the buyer.

How do I compare two quotes for this item?

Split both into metal, stone, labour, finishing and overhead, then compare line by line. A single total hides the specification difference.

Send the lab grown diamonds design and target price. We return a stone comparison with size tolerance, disclosure wording and the landed cost at each grade. See the full range at Lab Grown Diamonds and HOLYCOME.

Buyers who get consistent lots are not luckier. They wrote the spec down and checked the first carton against it.

Written by the Holycome manufacturing & quality team. Every figure and claim in this article comes from our own production floor in Wuzhou, China — in-house casting, stone setting and a three-pass quality inspection we have run since 2008.

Materials are tested for nickel, lead and cadmium release by SGS and CTT International; moissanite centre stones ship with their GRA warranty card and report. We also hold an independent SMETA / Sedex ethical-trade audit and a Hong Kong Customs AML registration.

Reviewed for accuracy by our quality team before publication. Last updated .